Skip to content
comparison

Electromagnetic vs Permanent Magnetic Separator: Cost and Use

Electro magnets reach deeper and can be adjusted; permanent magnets cost nothing to run and keep working through load shedding. Here is how to decide for your plant.

Latif Engineering4 min read

Almost every type of magnetic separator, from overband to drum to suspension magnet, comes in two versions: electromagnetic and permanent. The choice affects what the magnet can catch, what it costs to buy, what it costs to run, and what happens when the power goes. In Pakistan, that last point matters more than in most places.

The basic difference

  • An electromagnet uses a coil of copper or aluminium wire. When DC current flows through it, it becomes a magnet. Switch the current off and the field disappears.
  • A permanent magnet uses ferrite or neodymium blocks that are magnetic all the time. No power is needed to keep the field.

Comparison, point by point

Field depth

Large electromagnets can produce a deep field that reaches far into thick layers of material. This is why they are common over crusher feed conveyors and cane carriers where the burden is deep.

Adjustability

An electromagnet can be turned up or down by changing the current. A permanent magnet is fixed at the strength it was built with.

Running cost

An electromagnet draws power for as long as it runs and may need cooling. A permanent magnet uses no power for the magnet. Over years of continuous use, this difference adds up.

Power cuts and load shedding

When power fails, an electromagnet loses its field. On a separator, iron passes through until power returns, and anything it was holding falls back into the product. A permanent magnet keeps working at full strength.

This matters even more for lifting. An electric lifting magnet will drop its load if power fails unless it has a battery backup. A permanent magnetic lifter holds the load with no power at all.

Weight and size

For the same reach, large electromagnets can be heavy because of the copper coil and steel core. Modern permanent magnets, especially neodymium, are compact for their strength over short distances.

Purchase cost

This depends on size. For smaller units, permanent magnets are often cheaper. For very large, deep-reaching magnets, an electromagnet can be the only practical way to get the field required.

Maintenance

An electromagnet adds a rectifier, cabling, and coil insulation that must be kept cool and dry. A permanent magnet has none of these. It does slowly lose a little strength over many years, mostly when exposed to high heat.

Side by side, by product

How to decide

Choose electromagnetic when:

  • The burden is deep and the magnet must hang high.
  • Tramp iron is large and must be lifted from deep in the material.
  • You need to adjust the strength for different materials.
  • Power supply is reliable, or backup is available.

Choose permanent when:

  • Power cuts are frequent.
  • Running cost matters.
  • The distance to the material is moderate.
  • You want the simplest possible equipment with the least to maintain.

A practical note

Many plants in Pakistan run on a mix of grid power and generators, and a magnet that drops its iron every time the supply switches over is a real problem. If you choose an electromagnet, plan for that: put it on a protected supply, or add an interlock that stops the conveyor when the magnet loses power.

Not sure which suits your plant? Tell us the material, the burden depth, the kind of iron and how stable your power supply is. Request a quote and we will recommend the right one.

Frequently asked questions

What happens to an electromagnet during load shedding?

It loses its field. Iron passes through, and anything it was holding can fall back into the product.

Do permanent magnets lose strength?

Very slowly in normal use. High temperature is the main cause of strength loss.

Which is cheaper to run?

A permanent magnet, because it uses no power for the magnetic field.

WhatsApp us