Manufactured in Pakistan

Electro Suspension Magnet

Powered overhead magnet for stronger, adjustable tramp metal capture

The Electro Suspension Magnet is a fixed, plate-type electromagnet suspended over a conveyor or chute where a stronger or adjustable field is needed than a permanent suspension magnet can provide, but a fully self-cleaning overband is not justified. A powered coil generates a deep-reaching field that captures ferrous tramp metal on the underside of the housing, where it accumulates until cleared manually during scheduled maintenance. Field strength can be adjusted through the DC power supply to suit changing material or burden conditions, which is useful on lines that process varying products or occasional heavier tramp loads. It is commonly used as either a primary safeguard on moderate-duty lines or a stronger secondary check downstream of a drum separator.

• Adjustable field strength via DC power supply
• Stronger, deeper field than permanent suspension magnets
• Simple retrofit above existing conveyors or chutes
• Effective as primary or secondary protection
• Custom plate width per application
• Sealed housing resists dust and moisture
• Suitable for variable material and load conditions
• Rugged construction for industrial duty

Request a Quote WhatsApp Call

How it works

The unit is mounted above the material stream on a conveyor or inside a feed chute. An energised coil inside the housing generates a magnetic field that penetrates down into the material bed, lifting ferrous tramp metal against the underside of the plate. Because there is no discharge belt, captured metal builds up on the plate face rather than being continuously removed, so operators schedule periodic shutdowns to clear it before holding capacity is reached. The key advantage over a permanent suspension magnet is that field depth and strength can be tuned via the DC power supply, allowing the same unit to be set stronger for occasional heavy tramp loads or lighter for routine fine iron capture.

Specifications

Plate Width	300–2000 mm(Matches conveyor or chute width)
Magnetic Field Intensity	Up to 8000 Gauss(Adjustable via DC supply)
Power Supply	3-phase, custom coil rating
Site voltage confirmed at order	Mounting
Cleaning Type	Manual, scheduled clean-out(No discharge belt)

Final datasheet issued per confirmed application.

Applications

Moderate-duty conveyors and feed chutes, secondary protection with variable tramp loads, cement and quarry material handling, and lines where field strength needs to be adjustable rather than fixed.

Frequently asked questions

Why choose this over a permanent suspension magnet?

When you need adjustable or stronger field strength than a fixed permanent magnet can provide.

Why choose this over a self-cleaning overband?

When tramp metal loads are moderate enough that scheduled manual clean-out is practical and a simpler, lower-cost unit is preferred.

Can the field strength be changed after installation?

Yes, by adjusting the DC power supply to the coil.

Does power need to run continuously?

Yes, the field is only active while the coil is energised.

Request a quote

Quotation for the Electro Suspension Magnet

Five fields. You will have an indicative specification and price within two working days.